Péče o černý matný ruční mixér: jak zachovat nový vzhled

By KitchenAid® | Published: 2026-10-31

Category: Tipy a péče

Praktický postup krok za krokem, jak čistit a skladovat černý matný ruční mixér tak, aby tělo zůstalo bez šmouh a povrchová úprava si zachovala původní tovární vzhled.

Quick answer

Wipe the housing with a soft, slightly damp microfiber cloth after every use, keep liquids away from the vents, and store the mixer where nothing rubs against the matte finish. Skip abrasive sponges and solvent cleaners, which dull matte coatings quickly.

Why matte black shows more than gloss

Matte finishes scatter light instead of reflecting it, so fingerprints, flour dust, and dried batter smudges read as light patches against the dark surface. That visibility is the main trade-off of a black matte hand mixer: it looks understated on the counter but rewards frequent light cleaning more than a glossy housing would.

The finish itself is a surface coating, not bare plastic. Repeated scrubbing with scouring pads or harsh degreasers wears that coating thin in the spots you clean most, usually around the handle and the beaters' insertion area. Gentle, frequent wiping protects the look better than occasional deep scrubbing.

What to keep off the housing

Never submerge the hand mixer body in water or run it through a dishwasher; only the beaters and other removable attachments are meant to be washed. Water that reaches the vents can damage the motor, and that risk matters more than any cleaning shortcut.

Avoid solvent-based cleaners, bleach, and gritty cream cleansers on the housing. They can leave a chalky haze or uneven sheen on matte coatings. If a stain resists a damp cloth, a drop of mild dish soap on the cloth is the stronger step, not a stronger chemical.

Step-by-step matte finish care

Unplug and remove the beaters: Switch off, unplug the mixer, and release the beaters before you touch the housing. Wash only the beaters in warm soapy water. Checkpoint: the cord should be fully unplugged, not just switched off.
Wipe the housing while it is still dry: Brush off flour or crumbs with a dry microfiber cloth first. Wiping a dry mess with a wet cloth turns dust into a paste that settles into the matte texture. Common mistake: starting with a wet cloth on dry flour.
Damp-wipe with mild soap: Dampen a microfiber cloth with warm water and a drop of mild dish soap, wring it nearly dry, and wipe the handle, body, and around the vents without letting liquid enter them. Checkpoint: the cloth should feel barely damp, never dripping.
Rinse with a clean damp cloth: Go over the same areas with a second cloth dampened with plain water to lift soap residue, which can dry into a dull film on matte surfaces. Common mistake: skipping the rinse and leaving a soap haze.
Dry immediately and fully: Buff the housing dry with a clean, dry microfiber cloth, paying attention to seams and the area around the beater sockets where water can sit. Checkpoint: no visible moisture before storage.
Store without contact pressure: Coil the cord loosely, keep the beaters in their own container or bag, and place the mixer where nothing rests against the housing. Avoid cramming it against other appliances in a drawer. Common mistake: storing beaters loose against the body, which scuffs the finish.

Product facts

Contour Silver: The Contour Silver finish is described as clean and modern, with a hand mixer design built for comfortable, controlled use. A finish marketed for its look is worth protecting with the gentle routine below, and the comfortable grip means most wear will collect on the handle first.
Contour Silver